Term 3 - Week 1 - Coat Hanger

For the start of this term we are making a coat hanger. This is what I have drawn on sketchup so far:

Week 7

This week I did not do much. All I did was start to cut up the pieces for the draw. Next week I will be putting my draw together.

Week 5-6

This week I cut the two middle pieces, which will go in the housing joints I created earlier, to the correct sizes. And glued it all together. I also glued a piece along the spice rack, to prevent the spices, or what ever is going to be on there. from falling off. My kitchen rack now looks like this.

Week 4

This week I measured out and cut the housing joint into my two side pieces.

Tools:
- tri square
- tenon saw
- chisel
- mallet

Week 3

This week, after i cut out my design into the two side pieces, I sanded the both off so they are now exactly the same size and design.
Tools:
- oscillating sander

I also drilled the holes for the turned piece using a 25mm spade bit (making sure they lined up exactly).

Kitchen Rack - Week 2

This week I have started to make my kitchen rack. I have drawn and cut out the design into the frame:

Kitchen Rack - Week 1

This week I chose a design for my kitchen rack. This is my design which i have chosen:



















I have also started to construct a port folio this week.